Cyclus Tools Dual Disc Mount Facing Tool IS2000, Postmount and Flat Mount Wholesale

The dual disc mount facing tool can be used universally by simply changing the facer and clamping position. It mills 100% even, at a 90° angle. The exact 90 ° angle and the parallelism of the disc brake mounts are ensured by the fact that the facer is clamped only once and both disc brake mounts are milled simultaneously.

This is the only way to guarantee an absolutely identical milling depth, which is a prerequisite for the correct assembly and proper functioning of the disc brake. Before you clamp the face milling machine, you must check the parallelism of the dropouts, because only then is a 100% surface milling of the disc brake mount guaranteed.

Technical Details of the Dual Disc Mount Facing Tool

Flat Mount Frontfor front disc brake / front brake caliper mount according to flat mount standard Flat Mount Rearfor rear-wheel disc brake / rear brake caliper mountaccording to flat mount standard Post Mountfor disc brake / caliper mount according to postmount standardDiameter of the brake disc 140-203 mm(nominal size: 5-8 inches) International Standard 2000 (IS2000)for disc brake / caliper mount according to IS2000 standardDiameter of the brake disc 140-203 mm